3-5 Connecting to Printers
3-5 Connecting to Printers
Connecting a printer to an NS8, NS10, or NS12 PT makes it possible to obtain hard copy of
the contents displayed on the PT screen. Connect printers to the PT’s USB port. For details
on how to obtain hard copy of the PT display, refer to the Programming Manual.
3-5-1 Connection Method
Connect the printer to the PT’s USB port with a USB cable as shown below.
Note • Connecting or disconnecting the cable with power to the printer or the PT turned ON may
cause the PT to malfunction. Always turn OFF the power to the printer and the PT before
connecting or disconnecting cables.
• Do not connect an USB connector to any device that is not applicable.
• Before connecting an USB connector to a device, make sure that the device is free of dam-
age.
• Printing devices do not have the same general specifications as the PT. Printers may not
operate normally in locations subject to noise. When using a printing device, either install it
in a location that is not subject to noise or provide shielding.
Reference
Connect the printer directly to the PT with a cable. Connection via a USB hub is not
possible.
• Connecting Cables
Use one of the following cables.
NS-US22 (2 m, lock)
NS-US52 (5 m, lock)
• Supported Printer Standards
The following printer standards are supported.
ESC/P Raster
BJ Raster
• Recommended Printers
Operation checks have been performed for the following printers.
EPSON: PM-2200C, PM-930C, PM-870C, PM-740C, PM-G720
Stylus 900
CANON: BJ-M70
PIXUS 550i, 50i, 80i, iP2000, iP3100, iP4100, iP4100R
3-17
To Next Page
Loading...
Need help?
General
