A - 59
Appendices
NX-series Analog I/O Units User’s Manual for Analog Input Units and Analog Output Units (W522)
A-6 Version Information with
Communications Coupler Units
A
A-6-2 Connection to an EtherNet/IP Coupler Unit
The relationship between the unit versions of each Unit, EtherNet/IP Coupler Unit, CPU Unit and Indus-
trial PC, and versions of the Sysmac Studio and NX-IO Configurator are shown below.
The items that are used in the version combination tables are given below.
The version combination table is given below.
• With the combinations of the unit versions/versions shown below, you can use the functions that are
supported by the unit version of the Unit model. Use the unit versions/versions (or the later/higher
unit version/versions) that correspond to the NX Unit models and the unit versions. You cannot use
the specifications that were added or changed for the relevant NX Unit models and the unit versions
unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version, sup-
port is provided by the oldest available version after the specified version. Refer to the user’s manu-
als for the specific Units for the relation between models and versions.
• You cannot connect the relevant NX Unit to the target Communications Coupler Unit if “---” is shown
in the corresponding unit versions/versions column.
• If you use the corresponding unit versions/versions given in the following table or later/higher ver-
sions, refer to the version information in the user’s manual for the Communications Coupler Unit,
CPU Unit, and Industrial PC.
A-6-2 Connection to an EtherNet/IP Coupler Unit
Relationship between Unit Versions of Units
NX Unit Corresponding unit versions/versions
Model Unit version
Application with an NJ/NX/NY-series Con-
troller
Application with a CS/CJ/CP-series PLC
EtherNet/IP
Coupler Unit
CPU Unit or
Industrial
PC
Sysmac Stu-
dio
EtherNet/IP
Coupler Unit
Sysmac Stu-
dio
NX-IO Con-
figurator
Model num-
ber of NX
Unit
Unit version
of the NX
Unit
Unit version
of Ether-
Net/IP Cou-
pler Unit that
is compati-
ble with the
NX Unit
Unit version
of
NJ/NX-series
CPU Unit or
NY-series
Industrial PC
that is com-
patible with
the Ether-
Net/IP Cou-
pler Unit
Sysmac Stu-
dio version
that is com-
patible with
the NX Unit,
EtherNet/IP
Coupler Unit,
CPU Unit,
and Industrial
PC
Unit version
of Ether-
Net/IP Cou-
pler Unit that
is compati-
ble with the
NX Unit
Sysmac Stu-
dio version
that is com-
patible with
the NX Unit,
EtherNet/IP
Coupler Unit,
and CPU
Unit
NX-IO Con-
figurator ver-
sion that is
compatible
with the NX
Unit, Ether-
Net/IP Cou-
pler Unit, and
CPU Unit
To Next Page
Loading...
Need help?
General
