En-17
Basic Operation
Press the [ ON/STANDBY] button.
Alternatively, press the remote controller’s [] button.
The CD receiver comes on, and the display lights up.
If you insert an iPod/iPhone to the CD receiver, the
“Connecting” message will be shown and the
iPod/iPhone will be charged. Even if the CD receiver is
in standby mode, the “Charging” message will be shown
and charging will occur.
You can select CD, iPod, FM, AM, or LINE, which can
be an external component.
To select the input source, use the remote controller’s
Input Selector buttons. On the CD receiver, press the
[INPUT] button repeatedly.
The input sources are selected in the following order.
Press the VOLUME [+] button to increase the
volume or the VOLUME [–] button to decrease it.
You can also use the remote controller’s VOLUME
[–]/[+] buttons.
You can temporarily mute the output of the CD receiver.
Press the remote controller’s [MUTING] button.
The CD receiver is muted.
“Muting” appears on the display for a few seconds. The
MUTING indicator flashes continuously while the CD
receiver is muted.
To unmute the receiver, press the [MUTING] button
again.
Notes:
• Press the VOLUME [–]/[+] buttons on the CD
receiver or pressing the VOLUME [–]/[+] buttons on
the remote controller will unmute the CD receiver.
• If you turn the CD receiver off, the next time you turn
it on, the CD receiver will be unmuted.
You can connect a pair of stereo headphones (ø3.5 mm,
1/8-inch phone plug) to the receiver’s headphones []
jack for private listening.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the
headphones [] jack, the speakers are turned off.
To Next Page
Loading...
Need help?
General
