Onkyo NS-6130 User Manual

4
> Before Start >Part Names > Install > Initial Setup > Playback
Supplementary information | Advanced Setup | Others
E
N
Rear Panel
1. AC INLET: Connect the supplied power cord.
2. Wireless antenna: Used for Wi-Fi connection. Adjust their angles according to the
connection status.
3. USB port: Connect a USB storage device or HDD (hard disk drive) to play music files. You
can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
4. AUDIO OUTPUT DIGITAL COAXIAL jack: Connect a pre-main amplifier with digital
coaxial cable.
5. ETHERNET jack: Connect to the network with an ethernet cable.
6. REMOTE CONTROL jack: Connect an Onkyo product with an RI jack using the
included RI cable to synchronized with this unit. (P8)
7. AUDIO OUTPUT ANALOG jacks: Connect a pre-main amplifier with the included analog
audio cable.
    

180°
90°


Onkyo NS-6130 Specifications

General

Receiver type	Surround
Frequency range	4 - 70000 Hz
Audio output channels	- channels
Signal-to-Noise Ratio (SNR)	112 dB
Total Harmonic Distortion (THD)	0.002 %
Power output per channel (20-20KHz@8 Ohm)	- W
HDMI in	0
USB ports quantity	2
Ethernet LAN (RJ-45) ports	1
Connectivity technology	Wired & Wireless
Speakers connectivity type	RCA
Bluetooth	No
Ethernet LAN	Yes
Supported radio bands	-
Product color	Black
Audio formats supported	AAC, AIFF, FLAC, MP3
Package depth	388 mm
Package width	540 mm
Package height	210 mm
Package weight	5600 g
Cables included	AC
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Power consumption (typical)	22 W

Weight and Dimensions

Depth	317 mm
Width	435 mm
Height	100 mm
Weight	3500 g