Onkyo R-100 User Manual

How
to
Check
the
Timer
Reservation
Follow
the
procedures
below
for
checking
the
time
which
is
set
by
the
timer
reservation.
Example:
Checking
the
timer
setting
by
which
the
unit
starts
at
20:00
and
stops at 20:30.
ONEYVO fava TUNER AMPLIFIER 8-100
AUTO!
uate
ADIUST PROGRAM STAND-BY MONO.
Cort
CD Press the POWER ON.
@) Press PROGRAM two times in quick succession. __
““@ “CHECK” will come on, and then the time (20:00) when this
will come ON is displayed. “ON” will flash for 5 seconds.
Artistry in Sound
STEREO AUTO
® The “OFF” time (20:30) is displayed and the OFF indicator
flashes at the same time for 5 seconds.
TT
ie SB
Recording
on
the
Tape
Deck
from
the
Program
Source
CQ)
Select
the
desired
recording
source
with
the
SOURCE
button.
Q)
Begin
tape
deck
recording
operations.
@)
Begin
program
source
performance.
NOTE:
|
Be
careful
not
to
change
the
SOURCE
button
while
recording.
|
Video
Disc
Player
to
Video
Cassette
Recorder
Dubbing
Video
disc
programs
can
be
recorded
onto
VCR.
aM
Load
a
disc
in
the
video
disc
player,
and
a
blank
tape
in
VCR.
(2)
Select
the
VDP
by
using
the
SOURCE
button
[4].
3)
Begin
playback
of
the
video
disc
player
and
recording
of
the
VCR.
@
VDP
to
VCR
duplication
is
possible
when
VDP
output
is
con-
nected
to
the
VDP
jacks.
Refer
to
the
video
disc
player
and
VCR
instruction
manuals
for
additional
information.
Use
the
PROCESSOR
jacks
for
simultaneous
monitoring
of
recording
done
with
a
3-head
type
tape
deck.
(See
illustration
for
connections.)
R-100
TAPE
DECK
oO
Select
the
source
with
the
SOURCE
button.
Begin
tape
deck
recording
operation.
@
Begin
program
source
performance.
@)
Simultaneous
monitoring
of
a
recording
is
possible
by
setting
the
tape
monitor
switch
on
the
tape
deck
to
the
TAPE
position.
®
Be
careful
not
to
change
the
SOURCE
button
while
re-
cording.
©
Simultaneous
monitoring
of
a
recording
is
not
possible
with
a
2-head
tape
deck
or
a
DAT,
but
connection
is
possible.
Using a Mixing Console or Graphic Equalizer
Connect this unit's PROCESSOR OUT jack with the graphic
equalizer’s
INPUT
jack,
and
this
unit's
PROCESSOR
IN
jack
with
the graphic equalizer’s OUTPUT jack.
ae INPUT OUTPUT
Be
R-100 GRAPHIC EQUALIZER
If no processor or graphic equalizer is connected, use the jumper
plug provided to short the these terminals.
Equalizing Audio Source Performance
@)
Select
the
desired
listening
source
with
the
SOURCE
button.
(2) Begin performance.
NOTE:
Under DIRECT conditions, the equipment connected to the
processor
jacks
will
become
useless,
so
always
be
sure
DIRECT
has been canceled.

Onkyo R-100 Specifications

General

Brand	Onkyo
Model	R-100
Category	Amplifier
Language	English