44
Turning On the AV Receiver/AV Amplifier
STANDBY/ON
ON
RECEIVER
STANDBY
STANDBY indicator
Turning On and Standby
1
Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button, followed
by the [ON] button.
The AV receiver/AV amplifier comes on, the display lights up, and the STANDBY
indicator goes off.
Pressing the remote controller’s [ON] button again will turn on any components con-
nected via .
To turn the AV receiver/AV amplifier off, press the [STANDBY/ON] button, or press
the remote controller’s [STANDBY] button. The AV receiver/AV amplifier will enter
Standby mode. To prevent any loud surprises when you turn on the AV receiver/AV
amplifier, always turn down the volume before you turn it off.
or
AV amplifier
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver/AV amplifier before you
use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ XT)” on page 54.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 48, “Component Video
Setup” on page 49, or “Digital Input Setup” on page 51 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 50.
HDMI
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock
TX-SR705_En.book Page 44 Monday, May 28, 2007 2:13 PM
To Next Page
Loading...
Need help?
General
