49
First Time Setup—Continued
Notes:
• When the room correction and speaker setup is
complete, the “Equalizer Settings” (page 72) will be
set to “Audyssey” and the “Dynamic EQ” (page 74)
will be set to “On”.
• You can cancel the Room Correction and Speaker
Setup at any point in this procedure simply by
disconnecting the setup microphone.
Error Messages
While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
❏ Ambient noise is too high.
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the room correction and speaker setup.
❏ Speaker Detect Error
This message appears if a speaker is not detected. “Yes”
means that a speaker was detected. “No” means that no
speaker was detected.
One of the front speakers has not been detected.
One of the surround speakers has not been detected.
The surround back speakers have been detected but
the surround speakers haven’t.
The right surround back speaker has been detected
but the left surround back speaker hasn’t.
The speaker type detected does not match what was
expected. The speaker may be or incorrect type or
broken. Please check that it is the correct speaker
type, or that all drivers are working.
The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Make sure speakers that cannot be detected are
connected property.
Retry: Return to step 2 and try again.
Cancel: Cancel the room correction and speaker setup.
10
Disconnect the speaker setup
microphone.
Please unplug setup microphone.
2EQ: Auto Setup
Retry
Cancel
Ambient noise is too high.
2EQ: Auto Setup
2EQ: Auto Setup
Retry
Cancel
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : ---
C : Yes
FR : No
SR : ---
FHR : ---
SBR : ---
SW : ---
2EQ: Auto Setup
Retry
Cancel
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : ---
C : Yes
FR : Yes
SR : No
FHR : ---
SBR : ---
SW : ---
Retry
Cancel
2EQ: Auto Setup
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : ---
C : Yes
FR : Yes
SR : No
FHR : ---
SBR : Yes
SW : ---
Retry
Cancel
2EQ: Auto Setup
Speaker Detect Error
FL : Yes
SL : ---
FHL : ---
SBL : No
C : Yes
FR : Yes
SR : Yes
FHR : ---
SBR : Yes
SW : ---
Retry
Cancel
2EQ: Auto Setup
Speaker Detect Error
FL : Error
SL : Yes
FHL : ---
SBL : Yes
C : Yes
FR : Yes
SR : Yes
FHR : ---
SBR : Yes
SW : Yes
Retry
Cancel
Speaker matching error!
2EQ: Auto Setup
To Next Page
Loading...
Need help?
General
