pACK CONTENTS12 uSING ThE BABy mONITOr
(6) If only one camera is registered, then a short press of
this key will have no response.
(7) If more than one camera is registered then when that
camera is selected if the UP/Down button is pressed it
will turn on (C
√
) or turn off (CX) the camera during the
scan mode.
4.13 Video On / Off
The display can be turned off, the audio will still be
available for the camera units.
(1)
During video monitor mode, press and release <Power>
key, LCD is then turned off and receives sound from
camera (Audio only mode).
(2) During audio only monitor mode, if audio level on baby
unit is higher than VOX level then video turns on again.
(3) User also can turn the video on by pressing any key.
(4) If in scan mode audio will still be available for each
camera unit as it is scanned.
4.14 Scan Mode
When multiple cameras are registered to the parent unit,
the scan mode will cycle through each camera, displaying
the image for 10 seconds. The audio for the associated
image will be played, i.e. if camera 1 image is displayed,
you will receive the audio for camera 1. The parent unit
will continue to scan through all cameras connected. If
you need to view a camera for more than 10 seconds,
deactivate the scan mode.
To Next Page
Loading...
Need help?
General
