7uSING ThE BABy mONITOr
4 Using The Baby Monitor
Once the baby and parent units are powered on and
registered, the display on the parent unit will show the
video captured by the baby unit.
Switching on the Parent Unit
Press and hold the power button <
>forapprox.2seconds,
until the Oricom logo appears on the parent unit. The
camera image will then appear.
Press and hold the power button < >forapprox.2seconds
to switch the unit off.
NOTE:
If you place the parent and baby units too close together, you
will hear a high pitched noise called "feedback" and this is
normal. The units are designed to be located in separate
rooms.
To prevent feedback, do not take the parent unit into the
nursery/baby's room.
Feedback will be generated if the talk button is pressed
when the baby unit and parent unit are too close to each
other.
4.1 Parent Talk function
Press and hold < > button on the parent unit to talk to your
baby through the baby unit loudspeaker. The talk symbol
< > will be displayed in the middle of the LCD screen.
NOTE:
The lullaby will stop playing if the Talk function is activated.
4.2 Adjusting the volume of the parent unit
Press <
▲
> and < > to adjust the volume on the parent unit.
[ ] appears on the LCD screen. There are 5 levels to
choose from.
4.3 Playing a lullaby or white noise for your baby
Youcanremotelyactivatealullabytobeplayedonthe
baby unit.
(1) Press <
> button on the parent unit to play the
previous lullaby, [ ] appears on the LCD screen.
(2) Once the music starts to play, you have 8 sec to
change by pressing the <
▲
> and <
> keys. There are
3 lullabies and 2 white noise available for selection.
(3) Press <
> again to stop.
(4) If you want to change your selection after the 8 seconds
period, you will need to turn off the lullabies then turn
back on to make your new selection.
3 lullabies + 2 white noise include:
Lullabies:
Twinkle Twinkle
Silent Night
10 Minuet In G Major
White Noise:
Womb sounds
Vacuum Cleaner
To Next Page
Loading...
Need help?
General
