Page 16
Installation and Operation Manual - Inspire 2000
4.1 Cold Hand
The cold hand is a handle, supplied with the wood fire, which allows to open the door and avoid
burns. To open, insert the cold hand into the opening on the right side of the wood fire. Pull on
the cold hand to open the door. Push to close the door. The cold hand should not remain on the
wood fire when it is in use.
Figure 16: Right hand side opening Figure 17: Pull to open
4.2 Using a Blower
It is possible to install a blower on this wood fire. The
blower is optional and is sold separatly. See «Appendix 6.
Exploded Diagram and Parts List» for genuine part number.
The blower is installed on the back of the wood fire to
increase airflow through the heat exchanger and improve
hot air circulation in the room. When used regularly, the
blower can provide a small increase in efficiency, up to 2%.
However, the use of a blower should not be used as a way
to gain more output from a wood fire that is undersized for
the space it is intended to heat.
Figure 18: Air flow with a blower
Ensure the blower cord is not in contact
with any surface of the wood fire to prevent
electrical shock or fire damage. Do not run
cord beneath the wood fire.
To Next Page
Loading...
Need help?
General
