Set Frequency Mode (Three Door Mode Only)
CodeDodger® dual frequency 315/390MHz remotes are less susceptible
to interference when the receiver is operated in 315/390MHz mode. It is
recommended to leave the receiver in 315/390MHz mode when using
CodeDodger remotes unless also utilizing xed code remotes that operate
at 360, 380, or 412MHz. If the frequency mode is set to 360/390, 380/390, or
390/412MHz, CodeDodger 315/390MHz remotes will only work using 390MHz.
Set Frequency Mode to 315/390MHz (Default Frequency Setting)
Press and hold all three door buttons simultaneously. All three LEDs will turn
on. Continue to hold. The LEDs will turn o for two seconds and then back on
at ve seconds. Let go of the buttons at 10 seconds when the LEDs turn o. All
three LEDs will ash three times. The frequency on all three doors is now set to
315/390MHz.
PROGRAMMING RECEIVER
Set Frequency to 360/390MHz
Press and hold Door 1 and Door 2 buttons simultaneously. Door 1 and Door 2
LEDs will turn on. Continue to hold. The LEDs will turn o for two seconds and
then back on at ve seconds. Continue to hold. After 10 seconds Door 1 and
Door 2 LEDs will ash three times. The frequency on all three doors is now set to
360/390MHz.
Set Frequency to 380/390MHz
Press and hold Door 2 and Door 3 buttons simultaneously. Door 2 and Door 3
LEDs will turn on. Continue to hold. The LEDs will turn o for two seconds and
then back on at ve seconds. Continue to hold. After 10 seconds Door 2 and
Door 3 LEDs will ash three times. The frequency on all three doors is now set to
380/390MHz.
Set Frequency to 390/412MHz
Press and hold Door 1 and Door 3 buttons simultaneously. Door 1 and Door 3
LEDs will turn on. Continue to hold. The LEDs will turn o for two seconds and
then back on at ve seconds. Continue to hold. After 10 seconds Door 1 and
Door 3 LEDs will ash three times. The frequency on all three doors is now set to
390/412MHz.
To Next Page
Loading...
Need help?
General
