IV. Technical Specifications
Unless otherwise specified, the technical specifications applied are for VDS series only, and Probes attenuation set as 10X. Only if the
oscilloscope fulfills the following two conditions at first, these specification standards can be reached.
This instrument should run for at least 30 minutes continuously under the specified operating temperature.
If change of the operating temperature is up to or exceeds 5℃, do the "Self Cal" procedure in Utility menu
(see Self Cal).
Note: VDS1022(I) represents two types of machines, they are VDS1022I and VDS1022. VDS1022I contains isolation, while VDS1022 does
not contain isolation. The same as VDS2052(I).
To Next Page
Loading...
Need help?
General
