www.p-light.com since 2000
14
Electronics
Connecon of the P-LIGHT®
elektronics box
Use an RKKB cable for connecon of
P-LIGHT®. To ensure full charging and
funcon, the wires between the trailer’s
couplingconnector(totruck)andP-LIGHT®
terminals3,4and6on theelectronicsbox
must be Midi = min 1.5mm² / Maxi = min
2.5mm².
IMPORTANT: P-LIGHT® holds type approval
to ECE No. 10. For this to be valid, the
incoming cable connected to terminals 3-7
must be ed through the installed ferrite
core,seepictureonpage10.(notapplicable
toMidi).
Recommended connecon
LED bulbs of an approved variety are
recommended in order to provide the
best possible operang me. This is
recommendedinparcular ifP-LIGHT®will
beusedalotduringtheshiorifthe“winter
climate”oeninvolvestemperaturesbelow
freezing.(-20°Creducesbaerycapacitybya
factorof40-50%).
Thelawsofnatureforcurrent/voltageare
applicableforcalculaonofoperangmes
atdierentpowertakeos.
In a 24V system, 24 W (1 A) in load in
equivalenttoapprox.:1hourofoperaon/
baeryAh.
Midihasa 17Ahbaery,andwith a48W
takeoitgivesanoperangmeofapprox.
≈8h,24W≈ 17h,12W≈36h.Maxihasa
40Ah baery,which isequivalentto48W
≈20h,24W≈40h,12W≈80h.(Applicable
tofullychargedbaeriesingoodcondion
at+20°C).
Tighten the M8 screws to the lid by hand.
Max8-10Nmtoavoiddamagingtheplasc
trayandsealingstrip