CQ-DP133U/DP103U/DPX153U
E
N
G
L
I
S
H
2
11
E
N
G
L
I
S
H
1
10
CQ-DP133U/DP103U/DPX153U
POWER
REP
D•M
CLOCK
CQ-DP133U
D
ISP
TRACK
TUNE
LOUD
MUTE
7 8 9 10 11 12 SCAN
1
2
3
46
APM
B
A
N
D
SRC
5
V
O
L
U
M
E
P
U
S
H
S
E
L
DI
S
P
LOUD
MUTE
SRC
Anti-volume-blast circuit:
When the power is switched off and on
again, the volume slowly rises to the previ-
ous level.
The anti-volume-blast circuit will not work
when the volume level is set lower than
position 20 on the display.
Power and Sound Controls
Mute
Press [MUTE] to mute the sound completely.
lights
Press [MUTE] again to cancel.
Volume
Turn the knob clockwise to increase volume,
and counterclockwise to decrease volume.
Volume level (0 to 40)
Loudness
Press [LOUD] to enhance bass and treble tones at
low or medium volume.
lights
Press [LOUD] again to cancel.
Power
Turn the key in the ignition until
the accessory indicator lights.
Power on: Press [SRC] (POWER).
Power off: Press [SRC] (POWER)
again and hold.
Display Change
Press [DISP] (display) to switch to the clock display.
Note:
Please refer to next page when "AdJ" is displayed.
When the power is off:
No display Clock display
Remote control sensor
(only for CQ-DP133U/DPX153U)
Up
Down
POWER
REP
D•M
CLOCK
CQ-DP133U
DISP
TRACK
TUNE
LOUD
MUTE
7 8 9 10 11 12 SCAN
1
2
3
46
APM
B
A
N
D
SRC
5
V
O
L
U
M
E
P
U
S
H
S
E
L
DI
SP
TUNE
TRACK
Hours
w Press and hold [DISP] (display) for more than
2 seconds.
e Press [k TUNE] or [l TUNE].
Minutes
r Press [DISP] (display).
t Press [k TUNE] or [l TUNE].
y Press [DISP] (display).
Note: Press and hold [k TUNE] or [l TUNE] to
change numbers rapidly.
Audio Mode
(Bass/Treble/Balance/Fader/Sub Woofer)
Volume Bass Treble
BalanceSub Woofer
Fader
Note: If no operation takes place for more than 5 sec-
onds in audio mode (2 seconds in volume mode), the
display returns to the regular mode.
Bass:
Adjustable range: –12 to +12 (by 3dB step)
Treble:
Adjustable range: –12 to +12 (by 3dB step)
Balance:
R (right speaker) or L (left speaker)
Fader:
F (front speaker) or R (rear speaker)
Push [SEL] to select the audio mode.
q
Clock Setting
The 12-hour system is used for the clock.
(Hours blink.)
(Hours set.)
(Minutes blink.)
(Minutes set.)
(End.)
Initial Time
q Press [DISP] (clock).
"AdJ" is displayed when the clock is not
adjusted.
Time Reset
Press and hold [DISP] (display) for more than
2 seconds to activate the time setting mode to
reset the time. Then, repeat steps e to y.
[DISP] (clock)
[k TUNE], [l TUNE] (Hours, minutes)
Adjustable range: 1 to 15 (by 1 step) Balance center
Adjustable range: 1 to 15 (by 1 step) Fader center
(Only for CQ-DPX153U)
Sub Woofer:
Adjustable range (level): MUTE (0) to 8
(Only for CQ-DPX153U)
Push
Turn the knob clockwise or conterclockwise to
change each level.
w
To Next Page
Loading...
Need help?
General
