- 63 -- 63 -
4. Recording Videos - Time Code
[Time Code Display] Displays the time code on the recording screen.
[Count Up]
[REC RUN]: Counts the time code only when recording videos.
[FREE RUN]: Counts the time code also when video recording is stopped and when the
camera is turned off.
●
When the following function is being used, [Count Up] is fixed to [REC RUN]:
– [Variable Frame Rate]
[Time Code Value]
[Reset]: Sets to 00:00:00:00 (hour: minute: second: frame)
[Manual Input]: Manually input hour, minute, second and frame.
[Current Time]: Sets hour, minute and second to current time and sets frame to 00.
[Time Code Mode]
[DF]: Drop Frame. The camera modifies the difference between recorded time and time
code.
●
Seconds and frames are separated by “.”.
Example: 00:00:00.00
[NDF]: Non-Drop Frame. Records the time code without drop frame.
●
Seconds and frames are separated by “:”.
Example: 00:00:00:00
●
When the following functions are being used, [Time Code Mode] is fixed to [NDF]:
– [50.00Hz (PAL)] / [24.00Hz (CINEMA)] ([System Frequency])
– 23.98p [Rec Quality]
[HDMI Time Code Output] /
[SDI Time Code Output]
Images to be output via HDMI/SDI will be added with time code information then output.
●
The device screen may go dark depending on the connected device.
[External TC Setting]
Synchronize the time code default value with an external device that supports time code
input and output. (
64 / Synchronizing the Time Code with an External Device)
[TC Synchronization]: Selects the input ( 66 / Synchronize the Time Code of the
Camera with That of the External Device (TC IN)) and output (
65 / Synchronize the
Time Code of the External Device with That of the Camera (TC OUT)) for time code
signals. (LTC signal)
[TC Output Reference]: Sets the timing for time code signal output. ( 65 /
Synchronize the Time Code of the External Device with That of the Camera (TC OUT))
To Next Page
Loading...
Need help?
General
