6
Washing
Preparation: ● Check whether the washing machine has been properly installed. (P. 12)
● Turn on the water faucet.
1
After loading the laundry,
turn the power on.
2
According to the type of laundry and soil,
select the course.
e.g.) Normal course
■For reservation (P. 4)
After selecting the course, select how
many hours later you wish to complete
the entire operations.
(Indications other than “Reserve” turn off
in 2 minutes after start.)
● After reservation is set
• Change or cancel → Press “Off” and
do the procedure again.
• Check the course → Press “Program”.
• Check the reservation time
→ Press “Reserve”.
• Check the water level
→ Press “Water Level”.
3
Start.
The pulsator operates without water
and measures the load.
(approx. 5 seconds)
Water level indication
(approx. 5 seconds)
Remaining time indication
● To check the water level
→ Press “Water Level”.
Water begins to be supplied
(in approx. 30 seconds after start).
● When powdered detergent is poorly soluble, dissolve in
warm water before putting in.
● If there are many thick or large clothes (jeans, sheets, etc.)
in the tub, the detergent may remain dissolved. Dissolve
the detergent according to the above method, or reduce
the amount of laundry.
● If excessive bubbles form, reduce the amount of detergent
or change the detergent.
4
According to the water level,
put in the detergent.
(Follow the instruction
described on each
detergent’s container.)
5
Close the lid.
The operation is complete with the
buzzer sound.
For reservation
Select the course.
Turn the power on.
Start.
Water of approx. 30°C
(approx. 5 L)
• Put in the detergent little
by little while stirring to
prevent it from getting hard
or remaining in a powder
state.
NOTE
Powdered
synthetic detergent
Softener (P. 7)
Do not put
in here.
Liquid detergent
● Dilute sticky type
of detergent with
water before
putting in.
W9901-8AN00.indd 6W9901-8AN00.indd 6 8/9/12 9:55 AM8/9/12 9:55 AM
To Next Page
Loading...
Need help?
General