113
English
Copying the USB memory data to the
display
1
Insert the USB memory device,
which the data has been copied, to
the USB terminal of the display for
data copy (same as the step 1 on
page 112).
2
After the [Select copy type] screen is
displayed, go to the step 6.
When the [Select copy type] screen is not
displayed, follow the steps 3 to 5 to display.
Note
●
If the USB memory containing the data for
cloning is connected in power-on state, the
[Select copy type] message is displayed.
3
Display [Setup] menu pressing
<SETUP>.
4
Select [OSD language] with and
press <ENTER> for over 3 seconds.
The following display appears.
Options
Display software information
LAN data cloning
USB data cloning
Software licenses
Shipping
5
Select [USB data cloning] with
and press <ENTER>.
6
Select [USB Memory → Display] with
and press <ENTER>.
Select copy type
Display→USBMemory
USBMemory→Display
7
Select [YES] with and press
<ENTER>.
Data copy to the display starts.
Do you copy the data?
Data from USB memory
YES NO
The following message is displayed after data copy
has finished.
Cloning finished.
Please turn off the power.
8
After data copy has finished, remove
the USB memory device from the
USB terminal.
9
Turn the power off by switching the
<Main Power On / Off button>
( / ) OFF ( ).
The copied content is applied to the display.
●
If the <Main Power On / Off button> is locked,
please disconnect the AC cord plug from the
wall outlet.
●
When USB memory is not removed in the step
8, the message [Select copy type] is displayed
when the display is turned on again.
Note
●
If the data is copied with [POWER button lock] set to
[On], this function operates after turning the power
off, and the <Power button (Unit)> cannot be used
to turn the power on. In this case, remove the power
plug, wait sufficient time, and then connect the power
plug again to turn the power on.
●
[POWER button lock] function is only for TH-
65SF2U, TH-55SF2U, TH-49SF2U and TH-43SF2U.
To Next Page
Loading...
Need help?
General