19
Checking ultrasonic energy is transmitted in RF/
Ultrasonic mode
Transmission of ultrasonic energy cycles on and off for
approximately 1 second for each phase, but this will not
be felt by the skin. Use the following procedure to check
transmission of ultrasonic energy.
1. Place a few drops of water on the
ultrasonic probe (a).
• Orient the ultrasonic probe so that it
is level.
• We recommend that you use water
to check as it is more difcult if using
gel.
• Do not allow any other parts beside
the ultrasonic probe to come into
contact with water.
2.
Turn on the power and select the RF/Ultrasonic mode.
3. Use your nger to lightly press
on the ultrasonic probe
(a)
until the ultrasonic probe is
approximately the same height
as the frame (
b
).
4. Conrm the transmission.
• The water droplets will vibrate if the
appliance is operating properly.
(The vibration cycle lasts for
approximately 1 second.)
Frequently asked questions
Question Answer
What is RF and
ultrasonic energy?
RF is an acronym for radio
frequency. This is a type of
high‑frequency energy.
Ultrasonic energy includes
sound frequencies over
20 000 Hz that cannot be
heard by the human ear.
Can I use this
appliance on my
hands and other
areas of the body?
This product has been
designed specically for use
on the face. Use this product
only for beautifying the face.
Can I use the
appliance more
frequently than once
a day?
Use this appliance up to 12
minutes total of all modes (RF/
Ultrasonic mode and RF
mode) once during a day.
Use up to 3 times per week
and wait at least one day
between each use.
Overusing the appliance will
actually hurt your skin.
Why do I need to
apply gel or skin care
product?
This material helps transmit
the RF and ultrasonic energy
to the skin.
(Any air between the
ultrasonic probe and the skin
causes the RF and ultrasonic
not be transmitted.)
EH-XR10_EU.indb 19 2019/03/14 19:45:10
To Next Page
Need help?
General
