To disarm the system, shortly press button on the remote. You will hear 2 beeps and will see
2 flashes of the turn signals. The remote will play 'Disarming' ringtone and security mode status icon
will change to:
For disarming without sound confirmation press button for more than 1 second.
If there were new alarming events during the time system was armed, siren will sound 4 times,
and turn signals will flash 4 times, the remote will sound 'Warning' ringtone and will indicate zones
triggered. Detailed event history can be accessed by using CHECK button.
When disarming, two-step mode of unlocking the doors can be programmed. First
press
will disarm the system and unlock driver's door while second press will unlock all the other doors
*
.
0
0
*
*
- Disarming using a phone. 00* - disarming without sound confirmation
Unlocking the trunk
To independently unlock the trunk, no matter if the system is armed or not, press button
and hold it for 1 second.
If the system is armed when this action is performed, the trunk will be disarmed, shock and
supplementary sensors of the trunk will be disabled. All the other security zones will remain armed.
If in 15 seconds after using 'Unlock trunk' command, the trunk was not opened, the system will
lock it back, enable sensors and arm trunk security zone. This will be indicated with 1 flash of the turn
signals.
If the trunk was open when the system is armed and if it was not closed in 3 minutes, the system
will send warning message to the remote without triggering the siren.
* In some cars additional connection may be needed
~~
press and
hold for
1 sec.
Locking/unlocking doors when the engine is running
Locking and unlocking doors when the engine is running can be forced using a remote without
arming and when the ignition is switched on. To do this, shortly press
when the ignition is
switched on: doors will be unlocked. Pressing of
button will unlock the doors in the same way.
To Next Page
Loading...
Need help?
General
