Emergency immobilizer and Antihijack shutdown
To disable immobilizer and Antihijack in case of emergency, enter programming level 15 (see
'Control over system in case of emergency, entering PIN-code'). LED indicator will be lit green. Enter
the first digit of PIN-code using VALET button (press the button a number of times equal to the first
digit, pauses between presses should not exceed 1 second). The system will confirm entering with
red LED flash. Similarly enter second, third and fourth digits. The system will confirm correct PIN-code
with 2 beeps of the siren and with red flash of LED indicator.
To activate immobilizer and Antihijack functions, enter programming level 15. LED indicator will
be lit red. Press VALET button once, the indicator will be lit green and the siren will sound once.
Replacing immobilizer tag battery
After receiving a text message that immobilizer tag battery is low on the main owner’s phone
number, battery should be replaced soon. Battery type is CR2032.
Carefully open the cover of the tag's battery compartment. Extract discharged battery and insert
a new one keeping in mind the correct polarity. Replacing a battery will not cause a loss of tag code
information, as authorization data is stored in the non-volatile memory of the MCU.
Carefully close the cover of the tag's battery compartment. All elements of construction should
be rigidly locked in places. If it is so, the tag can be operated as usually.
Immobilizer code using original car controls
Code immobilizer is a function that allows disarming and controlling timer channels using
original car controls (button, lever or pedal). To enter immobilizer code, programmed button (lever,
pedal) should be pressed a number of times equal the digit of the code. Pauses between presses
should not exceed 1 second. Pauses more than 1 second will be interpreted as the start of next digit
input (can be a max of 4 digits 1 to 9).
If immobilizer code was correct, engine blocking will be disabled or a programmed timer channel
will be active (depending on the settings).
To Next Page
Loading...
Need help?
General
