Problem Solution
When pressing button 1 on the
LCD remote all icons are lit, when
pressing button 2 the numeric
indicator will be lit.
The remote is switched off, it needs to be switched on.
Press and hold button 3 (F) for 3 seconds.
LCD remote has stopped playing
ringtones.
Low battery power. Please, replace the battery (page 31).
Cannot disarm the system using a
remote.
Use additional remote or disarm using a phone command
(0*). Contact the car service that was installing the system.
LCD remote is vibrating constantly. Low battery power. Please, replace the battery (page 31).
One minute after the ignition was
switched off, ‘Signal lost’ ringtone
plays and LED indicator starts
flashing red.
The system reminds you that it is disarmed. Please, arm the
system.
The alarm constantly triggers
by shock and additional sensor
(warning/alarm level), motion and
tilt sensor.
The sensitivity is too high. Lower sensor sensitivity (page
26).
System does not send text
notifications.
1. Text message service center number is incorrect.
The system determines it automatically. However, it should
be changed if changing mobile operator of the system.
Contact the car service that was installing the system.
2. Text messaging is blocked by the mobile operator.
Contact your system’s mobile operator.
The system cannot be reached when
calling from supplementary owner’s
number.
When calling the system from any number, safe from main
owner’s number, guest PIN should be entered. Factory
preset PIN is 1-2-3-4. It can be changed in the settings.
The system cannot determine
owner’s number.
Some mobile providers use different country code prefixes
(e.g. +44 or 0 for UK). Please, use the correct prefixes that
your mobile operator uses when programming the system.
Any problem can be solved
To Next Page
Loading...
Need help?
General
