Digiplex DGP-848 - 1 - Programming Guide
Security and Access Control (DGP-848)
Programming Guide
Software Version 4.10
Default Installer Code
000000 (see section [800] on page 39)
Default System Master code
123456
How Do I Enter Programming Mode?
1. Press and hold the [0] key.
2. Enter your [
INSTALLER CODE].
3. Enter 3-digit [
SECTION].
4. Enter required [
DATA].
Decimal and Hexadecimal Programming Table
Certain sections may require the entry of one or more Hexadecimal values from 0 to F.
For LCD keypads:
For Grafica keypads:
[0] to [9] = values 0 to 9 respectively [DISARM] = D
[
STAY] = A [BYP] = E
[FORCE] = B [MEM] = F
[
ARM] = C [CLEAR] = Exit section without saving
[
ENTER] = Save current data and advance to next section
[0] to [9] = values 0 to 9 respectively Right Action Key (Exit) = Exit section without saving
[#]
= A to F (press the [#] key until the desired letter
appears)
Center Action Key (Save) =Save current data and advance to next
section
DGP-848
To Next Page
Need help?
General
