Parker EME
Introduction
192-120102 N7 - February 2004 9
2.3 Release 1/2004
You can read about the following in this chapter:
New Compax3 functions...................................................................................................................9
New functions of the Compax3 software tools ................................................................................10
Complements / corrections in manual and online help ....................................................................11
2.3.1. New Compax3 functions
You can read about the following in this chapter:
Direct drives .....................................................................................................................................9
Switching frequency of the power output stage can be set................................................................9
Optimization of the predefined external setpoint via the analog input................................................9
UL certification..................................................................................................................................9
New machine zero modes ..............................................................................................................10
RS485 / RS232 interface ................................................................................................................10
2.3.1.1 Direct drives
The feedback module F12 supports the following feedback systems:
! Distance coding with 1VSS - Interface
! Distance coding with RS422 - Interface (Encoder)
2.3.1.2 Switching frequency of the power output stage can be set
The switching frequency of the power output stage can be increased if necessary.
This helps mainly to reduce motor sounds.
Please note that power output stage losses increase with rising switching
frequency. Therefore the nominal device currents must be reduced.
2.3.1.3 Optimization of the predefined external setpoint via the analog
input
Given an external discrete signal read in via the analog input (possible with I10 T10
and T40), signal steps can only be avoided by averaging.
2.3.1.4 UL - certification
Compax3 now with UL certification. (see on page 16)
To Next Page
Loading...
Need help?
General