PBK 4 A1
■ 16
│
GB
│
IE
│
NI
Troubleshooting
Engine unit
Problem Possible cause Troubleshooting
The engine does
not start.
Incorrect start-up process.
Follow the instructions
regarding starting.
The engine starts
but does not run
at full power.
Incorrect adjustment of the
choke lever
.
Set the choke lever
to "
".
Contaminated air filter. Clean air filter.
The engine does
not run smoothly.
Incorrect spark plug gap.
Clean the spark plug
and adjust the spark
plug gap or replace
the spark plug.
Soot deposits or
wetness on the
spark plug.
Incorrect carburettor
adjustment.
Clean spark plug or
replace it with a new
spark plug.
Pole pruner
Problem Possible cause Troubleshooting
Motor is running,
saw chain
does not move.
Hedge trimmer attachment
or pole pruner attachment
is not connected properly
to the engine unit.
Check assembly.
No progress.
Saw chain
dry/over-
heating or is sagging.
Top up the oil or reg-
rind, replace or tighten
the saw chain
.
Hedge trimmer
Problem Possible cause Troubleshooting
Motor is running,
blades do not
move.
Hedge trimmer attachment
or pole pruner attachment
is not connected properly
to the engine unit.
Check assembly.
Maintenance intervals
Pole pruner
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and
longer daily operating hours, the given intervals are to be reduced corres-
pondingly.
Appli-
ance part
Action Before
starting
work
Weekly In the
event
of
faults
In the
event
of dam-
age
As re-
quired
Lubricat-
ing the
chain
Check X
Check
saw
chain
and pay
attention to
the sharp-
ness
X
Check
chain
tension
X
sharpen X
Check
guide
rail
(wear,
damage)
X
clean and
turn
XX
deburr X
replace X X
Check
sprocket
X
replace
X
Hedge trimmer
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and longer
daily operating hours, the given intervals are to be reduced correspond-
ingly.
Appli-
ance part
Action
Before
starting
work
After
com-
pletion
of work
As re-
quired
Cutting
blade
Visual inspection X
Cleaning X X
Ordering spare parts
Ordering spare parts
The following information should be provided when ordering spare parts:
■ Type of appliance
■ Item number of the appliance
■ Device ID number
Current prices and information are available at
www.kompernass.com
NOTE
■
Replacement parts which are not listed (e.g. strimmer, cutting filament)
can be ordered via our service hotline.
To Next Page
Loading...
Need help?
General
