Q Scope of delivery
1 Cordless drill PABS 16 B3
1 Battery pack PABS 16 B3-1
1 Rapid battery charger PABS 16 B3-2
1 PZ2 bit
1 Carrying case
1 Operating instructions
Q Technical data
Cordless drill: PABS 16 B3
Rated voltage: 16 V
Drill chuck type: keyless
Gearbox: 2 speed
No load speed n
0
: 1
st
gear 0 – 400 min
-1
2
nd
gear 0 – 1300 min
-1
Max. torque: 25 Nm
Max. chuck capacity: ø 10 mm
Max. drill diameter: into steel ø 10 mm
into wood ø 25 mm
Battery pack: PABS 16 B3-1
Type: Lithium ion
Rated voltage: 16 V
max.
Capacity: 2.0 Ah
Number of cells: 4
Rapid battery charger: PABS 16 B3-2
INPUT:
Rated voltage, frequency: 230 – 240 V
~
, 50 Hz
Power consumption: 50 W
OUTPUT:
Rated voltage: 16.5 V
Charging current: 2.4 A
Charging time: approx. 60 min
Protection class:
II /
Fuse (internal):
3.15 A
T3.15A
Noise emission value
Noise measurement value determined in
accordance with EN 60745. The A-rated noise
level of the power tool is typically as follows:
Sound pressure level L
pA
: 69 dB(A)
Uncertainty K
pA
: 3 dB
Sound power level L
WA
: 80 dB(A)
Uncertainty K
WA
: 3 dB
Vibration emission value
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Screwing
Hand / arm vibration a
h
: < 2.5 m/s
2
Uncertainty K: 1.5 m/s
2
Drilling into metal
Hand / arm vibration a
h,D
: 2.6 m/s
2
Uncertainty K: 1.5 m/s
2
WARNING!
Wear ear protection!
WARNING!
u The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions in
some cases. There is a risk of underestimation
of the vibration load if the power tool is
used regularly in this manner. Try to keep the
vibration loads as low as possible. Measures
to reduce the vibration load are, e.g. wearing
gloves and limiting the working time. Wherein
all states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
NOTE
u The vibration level specified in these
instructions has been measured in
accordance with a standardised measuring
procedure specified in EN 60745 and can
be used to make equipment comparisons.
The specified vibration emission value can
also be used to make an initial exposure
estimate.
Safety warnings
Q General power tool safety
warnings
WARNING!
u Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock,
fire and / or serious injury.
Save all warnings and instructions for
future reference.
The term “power tool” in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
7 GB / IE / NI / CY
To Next Page
Loading...
Need help?
General