Q Initial use
Q Unpacking
WARNING!
u The product and the packaging are not
children’s toys! Children must not play with
plastic bags, sheets and small parts! There is
a danger of choking and suffocation!
1. Unpack all parts and lay them on a flat,
stable surface.
2. Remove all packing materials and shipping
devices if applicable.
3. Make sure the delivery contents are complete
and free of any damage. If you find that
parts are missing or show damage do not
use the product but contact your dealer. Do
not use the product unless missing parts have
been delivered in addition or defective parts
have been replaced. Using an incomplete
or damaged product represents a hazard to
people and property.
4. Ensure that you have all the accessories and
tools needed for assembly and operation.
This also includes suitable personal protective
equipment.
Q Accessories
To operate this product safely and correctly, the
following accessories, i. e. tools and attachments,
are necessary:
o Suitable drill bits
o Suitable driver bits
o Cooling lubricant (cutting oil) suitable for
drilling in metal
o Suitable personal protective equipment
Accessories and tools are available through your
authorised dealer. When buying always consider
the technical requirements of this product (see
“Technical data”).
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer.
NOTE
u This instruction manual contains information
and suggestions for several attachments and
their uses. The attachments depicted are not
necessarily included in the shipment, but are
meant to indicate additional possibilities for
using this product.
Q Before use
Q Attaching / removing the
battery pack
CAUTION! RISK OF INJURY!
u Always lock the on / off switch to avoid
accidental starting by moving the rotation
control switch into the centre position before
attaching / removing the battery pack.
Attaching the battery pack:
1. Align the battery pack
8
to the handle and
slide it into it. Ensure it clicks noticeably in place.
Removing the battery pack:
1. Press the release button
9
and remove the
battery pack
8
.
Q Charging the battery pack
NOTE
u The battery pack
8
comes partly charged.
Charge the battery pack
8
prior to first use,
ideally at least 60 minutes.
u Always pull out the plug of the charger
11
from the mains before removing or connecting
the battery pack
8
to the charger.
u Never charge the battery pack
8
when
the ambient temperature is below 10 °C or
above 40 °C.
u If no battery pack
8
is inserted into the
charger
11
and the charger is connected to
mains, the charging status LED
13
lights up
green.
1. Connect the battery pack
8
to the battery
charger
11
.
2. Insert the mains plug into the socket. The
charging status LED lights
12
up red. Once
the battery pack
8
is completely charged,
the green charging status LED
13
indicates
that the charging process is complete.
3. Disconnect the charger
11
from the mains
and remove the battery pack
8
from the
charger.
4. Attach the battery pack
8
back to the
product (see “Attaching / removing the
battery pack”).
11 GB / IE / NI / CY
To Next Page
Loading...
Need help?
General