GB IE
10
How to connect/remove the
dust box
Connect the dust box
1. Push the dust box (4) on to the dust
extraction connector (8).
2. Press the xing lever (3). Push the dust
box (4) over the fastener for the dust
box (9). Release the xing lever (3).
The xing lever (3) will lock in place
on the fastener for the dust box (9).
Remove dust box
1. Press the xing lever (3).
2. Pull the dust box rearwards from the
dust extraction connector (8).
How to connect/remove dust
extraction
Connect dust extraction
1. Push the external dust extraction adap-
tor (7) as far as it will go on the dust
extraction connector (8).
2. Connect the extraction hose from a
vacuum cleaner to the external dust
extraction adaptor (7).
Remove dust extraction
1. Remove the extraction hose from the
external dust extraction adaptor (7).
2. Pull the external dust extraction adap-
tor (7) off the dust extraction connector
(8).
Do not use the tool without
the dust box tted or external
dust extraction.
Practical tips
When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Sanding
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
Selection of sanding sheet
Grain size P Application
60
for pre-sanding rough wood
surfaces
80 / 120 for plain sanding
240
for ne sanding of primed
and painted surfaces
To Next Page
Loading...
Need help?
General