Parkside PHSHE 900 A1 User Manual

17
NIIEGB
When wearing the shoulder strap,
ensure that the pad is placed on your
shoulders to increase comfort.
Sliding the carrying eye
You can slide the carrying eye (
A
17) to
better spread the weight of the device.
You may need to slide the soft grip
(
A
36) by turning and sliding to
achieve this.
1. Loosen both screws (
A
37) with an
Allen key (4 mm) (38).
2. Gently retighten the screws (
A
37).
3. Place on the shoulder strap and attach
the device to the shoulder strap. (See
“Attaching the shoulder strap”)
4. Slide the carrying eye (
A
17) until the
weight of the device is spread evenly.
5. Place the device down and tighten the
screws (
A
37).
A
Switching On and Off
Ensure that you are standing in a
-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. Make a loop in the end of the extensi-
on cable and suspend this in the cable
strain relief (15)
2.
Connect the device to the mains volt-
age.
3. To switch on, hold the safety
switch (12) depressed and simultane-
ously press the on/off
switch (13). The hedge trimmer will
be run at maximum speed. You can
release the safety switch (12) again.
4. The equipment will switch off again when
you release on/off switch (13).
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• To avoid eye injuries, always wear
safety goggles while working with the
hedge trimmer.

both hands, with one hand on the rear
handle and the other on the front han-
dle (
A


• Check the shoulder strap (
A
16) on a
pleasant position, which makes it easier
for you to hold the hedge trimmer.
• Switch off the equipment immediately
in the event that the blades are blocked
by solid objects, pull out the power plug
then remove the object.
• Always work away from the mains pow-
er outlet. Set the cutting direction before
starting work. Ensure that the power
cable is kept well away from the work-
ing area. Never lay the cable over the
hedge, where it could easily be caught
up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
Pull out the power plug im-
mediately if the cable is dam-
aged, badly twisted or has
been completely cut through.

Parkside PHSHE 900 A1 Specifications

General

Brand	Parkside
Model	PHSHE 900 A1
Category	Trimmer
Language	English