27 GB/IE
Before using
Check the consignment for completeness and for signs of
visible damage.
Remove all packaging material from the product.
Inserting / replacing the batteries
When the low battery icon appears in the display
3
, you
can still make measurements. As soon as the battery icon turns
empty
, however, you must replace the batteries. Measure-
ments are no longer possible.
Open the battery compartment cover
6a
by gently pushing
down the battery compartment cover latch.
Remove the used batteries from the battery compartment
6b
, if necessary.
Insert the (new) batteries. Ensure the correct polarity as
shown on the diagram inside the battery compartment
6b
.
Replace the battery compartment cover
6a
as shown
(fig. A).
Start-up
Switching on / off
To switch the product on, press the MEAS button
4
.
When the product is switched on, the laser beam is activate
d.
To switch the product off, press and hold the MEAS button
4
for approx. 5 seconds until the “OFF“ is shown on
display. If no button is pressed for about 3 minutes, the
product turns off automatically to save the batteries.
To Next Page
Loading...
Need help?
General
