To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if Parkside PLEM 50 A1 Analytical Instruments show error 220?
If your Parkside Analytical Instruments display error 220, it indicates a low battery. You should replace the batteries or charge them.
What to do if Parkside PLEM 50 A1 show error 500?
If your Parkside Analytical Instruments display error 500, which indicates a hardware error, try switching the device off and on. If the symbol persists after several attempts, please contact your dealer.
What to do if Parkside Analytical Instruments show error 255?
If your Parkside Analytical Instruments display error 255, it means the received signal is too weak or the measurement time is too long. To resolve this, improve the reflective surface by using a target plate or white paper.
What to do if Parkside PLEM 50 A1 show error 256?
If your Parkside Analytical Instruments display error 256, it indicates that the received signal is too strong. To fix this, improve the reflective surface by using a target plate, or avoid aiming at strong light sources.
Why Parkside Analytical Instruments show error 261?
Error 261 on your Parkside Analytical Instruments means that you are out of the measuring range. Ensure you are measuring the distance within the specified measurement range.
General| Type | Laser Distance Meter |
|---|---|
| Measuring accuracy | ± 2 mm |
| Laser class | 2 |
| Laser type | 635 nm, < 1 mW |
| Battery | 2 x 1.5V AAA |
| Dimensions | approx. 11.5 x 5 x 3 cm |
| Weight | approx. 85 g (with batteries) |
| Accuracy | ± 2 mm |
| Measuring range | 0.05 - 50 m |
| Operating temperature | 0 - 40 °C |
| Measurement Range | 0.05 - 50 m |
| Auto Power Off | Laser: 20 s / Device: 150 s |
| Automatic switch-off | Yes (after 150 s) |
Warning symbol for laser radiation safety.
Warning against staring into the laser beam.
Description of the device's keypad and its buttons.
Instructions for powering the device on and off.
Setting the measurement origin (front, rear, or end piece).
Procedure for taking a single distance measurement.
Steps to follow for making a warranty claim.
