EasyManuals Logo

Parkside PNTS 1500 C4 User Manual

Parkside PNTS 1500 C4
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
GB IE CY
Wet vacuuming
For wet suction/vacuuming or to suck up
water, place the foam lter (16) on the l-
ter basket (3b) on the motor head (3).
1. To avoid tearing the foam lter (16):
- Use only a dry lter;
- Before inserting, twist the edge of
the lter slightly and then roll it back.
2. Suctioning up (draining) water: place
the suction hose ( 21) on the handle
( 18) into the water tank and suc-
tion up the water.
3. Empty the container immediately after
vacuuming because it is not designed
to store liquids (see “Cleaning/Mainte-
nance”).
Never reach into the water to
be suctioned up. Danger of
electric shock.
When the container ( 6) is full,
the suction opening is shut off by
a oat, and suction is then cut off.
Switch the appliance off, remove
the plug from the socket and empty
the container (see Cleaning/Mainte-
nance).
If foam or liquid exits, switch off the
machine immediately.
Blowing
1. To blow instead of suck, push the vacu-
um hose (21) into the blow connection
(12), which then locks in places (op-
eration without using a lter).
2. To remove it, press the catch (21a) and
pull the vacuum hose (21) out.
Powertool vacuuming
The Powertool hose can be used for
the following:
Cleaning hard-to-reach places or sensi-
tive equipment.
Connecting powertools for vacuuming
dust off.
1. Attach the wider end of the power tool
hose (22) directly to the suction hose
(21). Attach the other end to the en-
closed reducer (23).
2. You can now t vacuum nozzles or an
electrical tool.
The reduction adaptor (23) also ts
onto the vacuum hose (21) (dust
vacuuming without the powertool
hose).
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
General Cleaning Work
Never hose the appliance
down with water. Never use
aggressive cleaning agents
or solvents. This could dam-
age the appliance.
After use, empty the container ( 6).
Opening the drain plug to allow the
vacuumed liquid to drain out ( 9).
Clean the container ( 6) with a
damp cloth.
Wash the foam lter ( 16) with luke-
warm water and soap, and allow to dry.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parkside PNTS 1500 C4 and is the answer not in the manual?

Parkside PNTS 1500 C4 Specifications

General IconGeneral
BrandParkside
ModelPNTS 1500 C4
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals