Parkside PWSAP 40-Li A1 User Manual

PWSAP 40-Li A1
GB
│
IE
│
3 ■
OUTPUT
Rated voltage 21.5 V (DC)
Rated current 4.5 A
Charging time approx. 50 min.
Protection class II /
(double insulation)
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise and vibration data
Noise measurement value determined in accord-
ance with EN62841. The A-rated noise level of
the power tool is typically:
Noise emission value
Sound pressure level L
PA
= 86.1 dB (A)
Uncertainty K = 3 dB
Sound power level L
WA
= 94.1 dB (A)
Uncertainty K = 3 dB
Wear ear muffs!
Total vibration value
Surface grinding
main handle a
h, AG
= 5.38 m/s
2
Uncertainty K = 1.5 m/s
2
Surface grinding
additional handle a
h, AG
= 5.73 m/s
2
Uncertainty K = 1.5 m/s
2
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
WARNING!
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illus-
trations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool“ in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
1. Work area safety
a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
2. Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.

Parkside PWSAP 40-Li A1 Specifications

General

Battery Voltage	40 V
Disc Diameter	125 mm
No-load Speed	8500 rpm
Spindle lock	Yes
Battery Type	Li-Ion