The following knowledge base article describes how to create self-signed certificates and import
it to a Peplink Product.
https://forum.peplink.com/t/how-to-create-a-self-signed-certificate-and-import-it-to-a-peplink-pro
duct/
24.3 Service Forwarding
Service forwarding settings are located at Advanced>Misc. Settings>Service Forwarding .
When this option is enabled, all outgoing SMTP connections destined for
any host at TCP port 25 will be intercepted. These connections will be
redirected to a specified SMTP server and port number. SMTP server
settings for each WAN can be specified after selecting Enable .
When this option is enabled, all outgoing connections destined for the proxy
server specified in Web Proxy Interception Settings will be intercepted.
These connections will be redirected to a specified web proxy server and
port number. Web proxy interception settings and proxy server settings for
each WAN can be specified after selecting Enable .
When this option is enabled, all outgoing DNS lookups will be intercepted
and redirected to the built-in DNS name server. If any LAN device is using
the DNS name servers of a WAN connection, you may want to enable this
option to enhance the DNS availability without modifying the DNS server
setting of the clients. The built-in DNS name server will distribute DNS
lookups to corresponding DNS servers of all available WAN connections. In
this case, DNS service will not be interrupted, even if any WAN connection
is down.
Custom Service
Forwarding
When custom service forwarding is enabled, outgoing traffic with the
specified TCP port will be forwarded to a local or remote server by defining
its IP address and port number.
To Next Page
Loading...
Need help?
General
