2-D LiDAR Sensor
Operation
2020-05
27
Back Menu Item
The "Back" menu item returns you to the higher-level menu.
6.3 Description of Menu Items
6.3.1 "Ethernet Info" Menu Item
This menu item provides quick access to the IP configuration currently in use. The
data can be read only in this menu item.
Address Mode
The address mode currently being used is displayed in this subitem.
IP Address
The IP address currently being used is displayed in this subitem.
Subnet Mask
The subnet mask currently being used is displayed in this subitem.
Gateway
The gateway currently being used is displayed in this subitem.
MAC ID
The MAC ID currently being used is displayed in this subitem.
6.3.2 "Ethernet Setup" Menu Item
This menu item is used to change the IP configuration data.
Address Mode
■ "Manual:" Enables you to manually assign the IP address, the subnet
mask, and the gateway to the device.
■ "DHCP:" Enables you to assign an IP address to the device from a DHCP
server (e.g., a Windows® PC).
■ "AutoIP:" Enables automatic detection of the device on the network.
IP Address
The IP address to be used in the "Manual" address mode can be set in this menu
item.
No function.
Keep the ARROW button or the ENTER button pressed for
> 1 second to go to the next menu element up.
Note
Changing the IP configuration
Changes to the IP configuration are only applied after a restart.
The IP configuration currently used by the device is displayed in the "Ethernet
Info" menu item. If these settings differ from the configuration specified under the
"Ethernet Setup" menu item, the device must be restarted.
To Next Page
Loading...
Need help?
General
