CHARGING THE BATTERY PACK
WARNING: Use only the
diagnostic charger supplied with the
tool to charge the 12 V Li-ion battery
supplied with the tool. Charging any
other batteries with this charger may
damage the charger, and possibly
cause serious injury.
1. To charge the battery, place the
charger (1) in a dry location near a
120 V AC, 60 Hz electrical outlet
(Fig. 1).
2. Place the battery stem (2) into the
matching cavity (3) in the top of the
charger.
NOTE: Make sure the battery is pressed
fully onto the charger as far as it will go.
3. Plug the battery charger into the
120 V AC, 60 Hz wall receptacle.
NOTE: Do NOT charge batteries when the
work area or the battery temperature is at
or below 0°C (32° F) or above
45°C (113° F).
When the battery charger is plugged into a
“live” receptacle, the battery charger will
begin charging the battery. The red LED
(4) and the green LED (5) on the top of the
charger will indicate the charging status
(Fig. 2).
To Next Page
Loading...
General