INSTALLING DRILL BITS – cont’d
WARNING: Do not insert drill bit
into chuck and tighten as shown in
Fig. 13. The drill bit MUST be properly
inserted with all three of the chuck jaws
holding the bit centred in the chuck. Failure
to properly insert drill bit could cause the
drill bit to be thrown from the chuck,
resulting in possible serious injury or
damage to the chuck.
REMOVING BITS
1. To open the keyless drill chuck, grasp
and hold the chuck collar and rotate it
in a counter-clockwise direction until
the chuck jaws open and release the
bit.
2. Remove the bit.
To Next Page
Loading...
General