CHARGER LED FUNCTIONS (Fig. 3)
Power ON
The green LED will stay ON when the
charger is plugged into a ”live” power
source.
Battery partially charged
The red LED will flash during charging.
Battery fully charged
When the battery is approximately 100%
charged, the red LED will turn OFF and the
green LED will blink for a short period of
time. The blinking green LED indicates the
charger is in trickle charge mode while
completing the charging cycle.
Under normal circumstances, the battery
will be fully charged in approximately
30–40 minutes.
NOTE: You may use the battery as soon
as the green LED begins to flash, as the
battery will be at least 98% charged.
Defective battery
The red LED will stay ON when a defective
battery is detected and it should be
replaced. Both the red and green LED’s
will stay ON when a defective battery is
detected and the battery is within the
normal charging temperature range.
NOTE: For additional help, call the
customer support toll free number
1-866-349-8665.
Too hot or too cold
Both the red LED and the green LED will
stay ON when the work area or battery
temperature is either too high or too low.
Remove the battery from the charger and
let it sit at room temperature 21° C (70° F)
for about one hour, and resume charging.
To Next Page
Loading...
Need help?
General
