CUTTING A HOLE IN WOOD FLOORING TO
INSTALL A HEATING VENT – cont’d
5. While holding the tool tightly, slowly
plunge the corner of the blade into the
flooring until it cuts through the
flooring. Once the plunge cut is
complete, set the tool to its highest
speed and complete the cut to the
corner of the rectangle.
6. Turn the saw OFF, remove it from the
cut and proceed to cut in the opposite
direction to complete the cut for the
first side of the rectangle.
7. Repeat steps #4, #5 & #6 to cut the
remaining three sides of the rectangle.
8. When all cuts are complete, use a flat
blade screw driver to carefully pry the
cut-out from the floor.
NOTE: Do NOT use the saw blade to pry
the cut-out from the floor. You will break
the blade. If the cut-out is not easy to pry
from the floor, check to make sure each
line is cut completely into the corner of the
rectangle.
CUTTING A HOLE IN DRYWALL FOR
INSTALLING AN ELECTRICAL OUTLET
BOX
The oscillating tool can be used to cut a
hole in drywall for installing an electrical
outlet box.
1. Install the half circle saw blade for
wood & drywall in the tool (Fig. 6
Page 18).
To Next Page
Loading...
