1
2
3
4
Preparations10
2-thread overlock converter
Engaging
7XUQRIIWKHPDLQSRZHUVZLWFKDQGXQSOXJWKHPDFKLQH
2-thread overlock stitches are sewn using one needle
thread and the lower looper thread. Before sewing, the
2-thread converter must be attached to the upper looper.
The 3-thread stretch overlock stitch is also sewn with the
2-thread overlock converter engaged.
• Open the front cover.
• Raise the white handle on the 2-thread converter to
LQVHUWWKHVKDUSHGJH$RIWKHFRQYHUWHULQWKHH\H%
of the upper looper.
Disengaging
7XUQRIIWKHPDLQSRZHUVZLWFKDQGXQSOXJWKHPDFKLQH
• Lower the white handle on the converter and remove
WKHVKDUSHGJH$IURPWKHH\H%RIWKHXSSHUORRSHU
Upper looper
Disengaging
For coverstitch and chaintitch sewing the upper looper
needs to be disengaged.
• Turn the handwheel until the upper looper is in its
lowest position.
• Push the clutch lever to the right and back until
position B is visible from the front.
Engaging
• Turn the handwheel until the upper looper is in its
lowest position.
• Pull the clutch lever toward you until position A is
visible from the front.
Changing to coverstitch table B
For coverstitch and chainstitch sewing the coverstitch
table B should be used.
/LIWWKHKRRNWRUHOHDVHWKHFXWWHUFRYHU$DQGSXOOLW
towards you.
,QVHUWWKHFRYHUVWLWFKWDEOH%E\ÀWWLQJWKHWZRIURQW
SLQVLQWRWKHKROHVDQGPDNHVXUHWKHKRRN
clicks into place.
To Next Page
Loading...
Need help?
General
