1
2
3
1
10
8
4
5
6
7
8
9
10
11
5
C
B
A
2
Threading14
Threading chainstitch looper (purple)
• Raise the presser foot to release tension discs.
• Pass the thread from back to front through the thread
JXLGHRQWKHWKUHDGVWDQG
• Thread the top cover thread guide by pulling the
thread towards the right until it slips under the guide.
Then pull the thread along the right side of the button
DVLOOXVWUDWHG
• Lift up the handle and bring the thread under it. While
holding the thread with both hands, pass it between
the tension discs and pull it down to make certain it is
SURSHUO\SODFHGEHWZHHQWKHWHQVLRQGLVFV
• Turn the handwheel toward you until the chainstitch
looper is at the far right.
• Thread the looper area of the machine following the
SXUSOHFRORUFRGHGWKUHDGJXLGHV
3ODFHWKHWKUHDGWKURXJKWKUHDGLQJJXLGH
• Place the thread through the front slot of threading
JXLGH
7KUHDGWKHFKDLQVWLWFKWKUHDGJXLGHE\KROGLQJWKH
thread in front of the thread guide pin and pulling the
thread backward and up, until the thread rests inside
the thread guide loop and under the spring.
7RWKUHDGWKHODVWWKUHDGJXLGHSXOODERXWFP
µRIWKUHDGWKURXJKWKHJXLGH
7LS0RYLQJWKHVWLWFKÀQJHUOHYHUWR5PDNHVWKHWKUHDGLQJ
HDVLHU5HPHPEHUWRVHWLWEDFNWR1EHIRUHVWDUWLQJWRVHZ
7KUHDGWKHORRSHUH\H$IURPIURQWWREDFNXVLQJWKH
WZHH]HUV0DNHVXUHWKHWKUHDGUXQVLQWRWKHOHIW´9µ
FXWRXW%RQWKUHDGHUOHYHU)LUPO\KROGWKHWKUHDGWDLO
ZLWKOHIWKDQGDQGSXOOWKHWKUHDGHUOHYHU&XSLQWR
place and back to snap the thread into thread guide 10.
To Next Page
Loading...
Need help?
General
