1
1
2
3
4
5
6
7
8
9
9
2
Threading12
Threading the upper looper (red)
• Raise the presser foot to release tension discs.
• Pass the thread from back to front through the thread
JXLGHRQWKHWKUHDGVWDQG
• Thread the top cover thread guide by pulling the
thread towards the right until it slips under the guide.
Then pull the thread along the right side of the button
DVLOOXVWUDWHG
• Lift up the handle and bring the thread under it. While
holding the thread with both hands, pass it between
the tension discs and pull it down to make certain it is
SURSHUO\SODFHGEHWZHHQWKHWHQVLRQGLVFV
• Thread the looper area of the machine following the
UHGFRORUFRGHGWKUHDGJXLGHV
• Use the tweezers to thread the hole in the upper looper
IURPIURQWWREDFN
3XOODERXWFPµof thread through the looper and
place it to the back of the stitch plate.
To Next Page
Loading...
Need help?
General
