6
Presser feet
Important: Make sure that the IDT™ system is disengaged when using presser foot 2A, 5B.
Standard presser foot 0A with IDT™ system (shown as in the
display, attached on the machine upon delivery)
This foot is used mainly for straight stitching and zigzag stitching with a
stitch length longer than 1.0 mm.
Fancy stitch foot 1A with IDT™ system (shown as in the display)
This foot is used for decorative stitches. The groove on the underside of the
IRRWLVGHVLJQHGWRÁRZVPRRWKO\RYHUWKHVWLWFKHV
Fancy stitch foot 2A (shown as in the display)
When sewing decorative stitches or short zigzag stitches and other utility
stitches with less than 1.0 mm stitch length, use this foot. The groove on the
XQGHUVLGHRIWKHIRRWLVGHVLJQHGWRÁRZVPRRWKO\RYHUWKHVWLWFKHV
Blindhem foot 3 with IDT™ system (shown as in the display)
This foot is used for blindhem stitches. The toe on the foot guides the
fabric. The red guide on the foot is designed to ride along the fold of the
hem edge.
Zipper foot 4 with IDT™ system
This foot can be snapped on either the right or the left of the needle,
making it easy to sew close to both sides of the zipper teeth. Move the
needle position to the right or left to sew closer to zipper teeth.
One step Buttonhole foot 5B (shown as in the display)
This foot has a space in the back to set the size of the buttonhole. The
PDFKLQHZLOOVHZDEXWWRQKROHWRÀWWKDWEXWWRQVL]H
To Next Page
Loading...
Need help?
General
