- Folliculitis (swelling around hair follicles combined with pustule
formation): this reaction occurs very rarely and is the result of
bacteria penetrating the damaged skin. In case this reaction occurs,
we advise you to consult a doctor as folliculitis may need antibiotic
ointment.
- Excessive pain: this can occur during or after treatment if you have
used the device on skin that is not hair-free, if you use the device
at a light intensity that is too high for your skin tone, if you ash
the same area more than once and if you use the device on open
wounds, inammations, infections, tattoos, burns, etc.
Aftercare
After use, you can safely apply lotions, creams, deodorant, moisturizer
or cosmetics to the treated areas. If you experience skin irritation or skin
redness after treatment, wait until it disappears before applying any product
to your skin. If you experience skin irritation after applying a product to your
skin, wash it o with water.
Note: when following all instructions you may still get skin reactions. In this
case stop using the device and contact the consumer care center in your
country.
Cleaning & storage
After use, switch o the device, unplug it and let it cool down.
1 Remove the attachment.
2 Moisten the soft cloth supplied with the device with a few drops of water
and use it to clean the following parts:
- the light exit window
- the outside surface of the attachments
- the reector inside the attachments
- the reddish lter glass inside the facial attachment.
3 Let all parts air dry thoroughly.
4 Store the device in a dust-free and dry place at a temperature between
0 °C and 60 °C.
22
English
4222_100_4214_3_HR.indd 22 05/04/17 16:26
To Next Page
Loading...
Need help?
General
