17 TV / DVD device mode selection keys:
• select TV or DVD mode.
• blink when the remote control is set up for the
selected device.
• light up when a remote control command is sent
to the selected device.
Note
If the device does not respond at all, or not to all of the key commands,
follow the instructions under ‘2.3 Setting the remote control’.
4 Extra possibilities
4.1 Adjusting device selection (Mode keys)
The SRU 5120 is default set for operating TV or DVD.
You can select the device you wish to operate with the TV and DVD
keys. Each mode key allows operation of one device only. If desired, you
can program the keys to select a different kind of device. For example, if
you want to operate a second TV. In the following example you will see
how to configure the DVD key for a second TV.
Switch on the second TV.
Press the DVD key to select DVD.
• The key lights up.
Then keep keys 1 and 6 on the SRU 5120 pressed simultaneously for
three seconds, until the DVD key lights up.
12
12
3
11
11
2
1
8 Extra possibilities
ENGLISH
To Next Page
Loading...
Need help?
General
