Refitting
STEERING FIFTH WHEEL TRACK FITTING
- Thoroughly clean the track seats on the head-
stock and the steering tube.
- Fit the new tracks of the headstock with the spe-
cific tool.
- Screw the nut until the tracks are fully inserted.
N.B.
LUBRICATE THE STEERING FIFTH WHEEL TRACKS WITH
RECOMMENDED GREASE BEFORE USE.
Specific tooling
001330Y Tool for fitting steering seats
001330Y014 Tool for fitting steering seats
001330Y015 Tool for fitting steering seats
Recommended products
AGIP GREASE PV2 Grease for steering bear-
ings, bolt seatings for swinging arms and fay-
ing surface of driven pulley spring (only pulley
side)
Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2
- Fit the lower fifth wheel seat on the steering tube.
- With a tube of the indicated sizes, fit the lower
seat until it stops. Inside Ø: 35.5 mm; Outside Ø:
38 mm; Length: 350 mm.
N.B.
LUBRICATE THE STEERING FIFTH WHEEL TRACKS WITH
RECOMMENDED GREASE BEFORE USE.
Recommended products
AGIP GREASE PV2 Grease for steering bear-
ings, bolt seatings for swinging arms and fay-
ing surface of driven pulley spring (only pulley
side)
Beverly Tourer 250 i.e. Suspensions
SUSP - 217
To Next Page
Loading...
