- Undo the screw «B», then remove cover «C» in
order to get access to the reservoir cap below.
- Loosen the two fixing screws «D» and remove
cover «E». Top-up the brake fluid level using only
the prescribed brake fluid and without exceeding
the maximum level.
Under normal climatic conditions, replace fluid as
indicated in the scheduled maintenance tables.
CAUTION
BRAKING CIRCUIT FLUID IS HIGHLY CORROSIVE; MAKE
SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
WARNING
THE BRAKE FLUID IS HAZARDOUS: IN CASE OF ACCI-
DENTAL CONTACT, WASH OFF WITH WATER.
WARNING
THE BRAKING CIRCUIT LIQUID IS HYGROSCOPIC, AND
ABSORBS THE HUMIDITY OF SURROUNDING AIR. IF THE
HUMIDITY IN THE BRAKING FLUID EXCEEDS A CERTAIN
VALUE, IT WILL LEAD TO INEFFICIENT BRAKING. NEVER
USE BRAKING FLUID KEPT IN CONTAINERS THAT HAVE
ALREADY BEEN OPENED, OR PARTIALLY USED.
Recommended products
AGIP BRAKE 4 Brake fluid
FMVSS DOT 4 Synthetic fluid
Headlight adjustment
Proceed as follows:
- Position the unloaded vehicle, in running order
and with the tyres inflated to the prescribed pres-
sure, onto a flat surface, 10 m away from a half-lit
white screen; make sure the vehicle axis is per-
pendicular to the screen;
- Turn on the headlight and check that the border
of the projected light beam on the screen is not
Beverly Tourer 250 i.e. Maintenance
MAIN - 39
To Next Page
Loading...
Need help?
General