03_04
03_05
03_06
Engine oil change (03_04, 03_05, 03_06)
Oil must be changed and filter replaced at an Authorised Service Centre (as indi-
cated in the Scheduled Maintenance Table). The engine should be emptied by
draining the oil through drainage plug «B » of the mesh filter on the flywheel side. In
order to facilitate oil drainage, loosen the cap/dipstick «A». Since a certain quantity of
oil remains in the circuit still, the top-up should be carried out from the cap«A».
Then start up the vehicle, leave it running for a few minutes and switch it off: after
about five minutes check the level and if necessary top up without exceeding the
MAX level.
The cartridge filter must be replaced every time the oil is changed. For top-ups and
changes use new oil of the recommended type.
WARNING
RUNNING THE ENGINE WITH INSUFFICIENT LUBRICATION OR WITH INADE-
QUATE LUBRICANTS ACCELERATES THE WEAR AND TEAR OF THE MOVING
PARTS AND CAN CAUSE IRRETRIEVABLE DAMAGE.
CAUTION
USED OILS CONTAIN SUBSTANCES HARMFUL TO THE ENVIRONMENT. FOR
OIL CHANGE, CONTACT AN AUTHORISED SERVICE CENTRE WHICH IS EQUIP-
PED TO DISPOSE OF USED OILS IN AN ENVIRONMENTALLY FRIENDLY AND
LEGAL WAY.
Recommended products
eni i-Ride PG 10W-40
Synthetic-based lubricant for four stroke engines.
JASO MA, MA2 - API SL - ACEA A3
36
To Next Page
Loading...
Need help?
General