Automatic transmission
Transmission cover
- Loosen the 15 screws and remove the transmis-
sion cover with the aid of a mallet.
N.B.
THE CRANKCASE IS SLIGHTLY BLOCKED BY THE TIGHT
FIT BETWEEN THE SHAFT OF THE DRIVEN HALF-PULLEY
AND THE BEARING HOUSED ON THE CRANKCASE.
Kickstart
- Remove the screws shown in the figure and re-
move the engine starting lever.
- For the assembly, work in reverse and tighten the
screws to the prescribed torque..
Locking torques (N*m)
Starter lever replacement 12 to 13 Nm
- Remove the seeger ring located on the exterior
of the crankshaft.
- Dismantle the dog gear from its seat, slackening
the tension that the toothed sector applies to it by
means of the spring; to do this, it is necessary to
rotate the toothed sector slightly (see the figure).
CAUTION
WHILE REMOVING THE TOOTHED SECTOR, BE VERY
CAREFUL OF THE SPRING TENSION: IT COULD CONSTI-
TUTE A HAZARD FOR THE OPERATOR.
Engine Liberty 50 Catalyzed
ENG - 60
To Next Page
Loading...
Need help?
General