After extracting the «MASTER» key «A», insert, within ten seconds, the key that is
going to be programmed «B» and turn it immediately to «ON». After 1-3 seconds, turn
the key to «OFF» again and pull it out. In this way, a maximum of 7 keys can be
programmed by repeating the above procedure and keeping the indicated times.
FINAL STAGE
After extracting the key to be programmed «B», insert the «MASTER» key «A» again
and turn it to «ON» (perform this operation within the 10 seconds following the ex-
traction of the previous key). Leave it in this position for 1 to 3 seconds and return it
to «OFF».
01_22
CORRECT PROGRAMMING CHECK PHASE
Insert the «MASTER» key «A» disabling the transponder «C» (i.e., by tilting the key
cap by 90°), and turn the key to «ON». Perform the engine starter operation. Ensure
that the engine does not start. Insert the programmed key «B» and repeat the starter
operation. Check that engine starts.
WARNING
SHOULD YOU START THE ENGINE WITH THE MASTER KEY (WITH TRANS-
PONDER OFF) OR IN THE EVENT OF WRONG OPERATION DURING PROGRAM-
MING, REPEAT THE PROCEDURE FROM THE BEGINNING.
22
To Next Page
Loading...
Need help?
General
