Contact an Authorised Service Centre and bring the «A» MASTER key and all
«B» starter keys that you own.
The codes of starter keys not submitted for the new programming procedure are de-
leted from the memory. Any lost starter keys will therefore not be enabled to start the
engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
SHOULD THE VEHICLE CHANGE OWNER, IT IS ABSOLUTELY NECESSARY
THAT THE NEW OWNER GET POSSESSION OF THE KEY WITH THE MASTER
GRIP (AS WELL AS ALL OTHER IGNITION KEYS).
Programming the immobilizer system (01_22)
Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to «RUN».
START PROCEDURE
Insert the «MASTER» key «A» into the ignition switch (in «OFF») and turn it to
«ON». After 1 - 3 seconds, turn the key to «OFF » again and pull it out.
INTERMEDIATE STAGE
21
To Next Page
Loading...
Need help?
General
